WiFi 6 Guide Smart Board for Mall Directory, WF-G3399, AndroidSBC, Genoa

TL;DR: WiFi 6 Guide Smart Board for Mall Directory

AndroidSBC peripheral desk: guide kiosk touch, scanner and printer driver SDK declared production-ready serving Genoa, Italy. The WF-G3399 smart guide kiosk Android motherboard spans the dual-screen high-definition guide kiosk and eleven sister models in the WF-G series, all built on the RK3399 dual Cortex-A72 1.8GHz plus quad Cortex-A53 64-bit SoC with the ARM Mali-T860 MP4 GPU, dual HDMI 2.0 4K output plus eDP, and Android 11 firmware support. AndroidSBC, the export arm of Wanlin Manufacturing Group, ships the WF-G family from the Longgang source factory in Shenzhen to Genoa and Italy importers who run mall directory, wayfinding, information point, dual-screen promotion, interactive display and outdoor smart city programmes.

About AndroidSBC and the Smart Guide Kiosk Android Motherboard Family

Why a source factory rather than a trading company: the WF-G smart guide kiosk Android motherboard family is designed, laid out, assembled and tested by Wanlin Manufacturing Group in Shenzhen, which means Genoa integrators deal with the people who control the BOM. Custom display interfaces, custom touch controller pairing, custom memory and storage splits, custom dual-screen configurations and custom payment or ID reader interfaces are all changes that happen at the schematic and layout stage rather than as a favour from a middleman. Italy buyers also get the failure analysis loop: when a board comes back, the report comes from the line that built it, not from a distributor forwarding a ticket. Certification, carton labelling and palletisation for Italy are prepared in Shenzhen by the export desk before the Genoa shipment leaves, and the test reports stay versioned against the board revision.

WF-G3399 Technical Specifications

All parameters in the table above are measured at 25C ambient. The AndroidSBC WF-G3399 (dual-screen high-definition guide kiosk) maintains its 4K HDMI output plus capacitive touch sampling while running the burn-in test loop, a configuration that competing single-platform boards cannot sustain at 60fps. For Italy importers sourcing the WF-G family, the WF-G3399-A variant is the typical configuration for the hotel lobby and resort directory terminal use case, with a sustained weekly capacity of 5000 pcs/wk.

Challenges in Sourcing Smart Guide Kiosk Android Motherboards for Italy Buyers

The sixth obstacle is lifecycle mismanagement. Genoa programmes that start on a legacy part find themselves two years in with no spare boards, no firmware source and no migration plan, and Italy venue fit-out cycles are longer than the parts remain in production.

The content stack is open by design. AndroidSBC documents the cloud content management client, the kiosk-mode lockdown layer and the directory and wayfinding interface on the WF-G family, and provides Italy integrators with a versioned SDK so the Genoa deployment can be extended without forking the image. AndroidSBC has now closed the 8th consecutive quarterly window on this family, with 55800 boards scheduled for Genoa and Italy on the Genoa - Shanghai lane as of September 18, 2026.

Competitive Comparison: WF-G3399 vs Competing Smart Guide Kiosk Android Boards

The shortlist conversation in Genoa and Italy rarely turns on clock speed alone. It turns on how quickly a visitor can go from standing in front of a directory to knowing which floor to walk to, and which board vendor has already solved the touch panel, the compliance files and the update path for that moment.

• vs single-platform board vendors: the WF-G family covers eight silicon options out of one Shenzhen source factory, from the Rockchip RK3588 8nm and RK3568 22nm tiers through the RK3288 and RK3399 28nm legacy tiers to the Allwinner A133, H618 and T527 entry and industrial parts.
• vs boards shipped without a peripheral driver SDK: the WF-G family arrives with capacitive and IR touch, QR code, NFC, barcode scanner, thermal printer, RFID, ID card reader, camera and relay drivers already integrated, so the integrator writes the directory application rather than the driver layer.
• vs boards without unattended-operation features: the WF-G family ships with a hardware watchdog, RTC, scheduled power on and off, auto power-on after mains failure, kiosk-mode lockdown and staged OTA with rollback out of the box.
• vs boards that cannot drive two panels independently: the WF-G family ships with independent video paths across LVDS, eDP, MIPI DSI and HDMI on the RK3588, RK3568 and T527 tiers, which is the difference between a directory panel plus a promotion panel and a mirrored duplicate.

Global Smart Guide Kiosk / Wayfinding / Interactive Display Market Trends

Refresh cycles are lengthening, which favours multi-tier families. Analysts covering Italy retail and venue technology report that kiosk and directory estates are being specified for seven to ten years rather than three to five, and Genoa programmes are following. That changes the dual-screen high-definition guide kiosk question from which board is cheapest today to which vendor can still supply the same board, or a documented equivalent, in year eight.

• Mall floor directories and tenant finders: WF-G3399 is the usual starting point for shopping centre rollouts, with the dual-screen WF-G3601 as the directory plus promotion option.
• Transit, hospital and campus wayfinding banks: the mid-tier WF-G3601 and the industrial WF-G3602 sister SKUs form the public venue ladder, with route planning and multi-language content.
• Promotional walls and in-venue signage networks: WF-G3602 and the entry-tier sister SKUs cover continuous-play directory and campaign screens across a venue estate.

AndroidSBC shares the source tables behind these figures with Genoa and Italy integrators on request, including the segment splits used for planning.

Partner Success Story: Levant Mall Services (mall operations services provider)

A Levant Mall Services programme in the GCC shopping centres segment illustrates how the WF-G family from AndroidSBC supports Genoa integrators on the ground. Levant Mall Services deployed 55800 WF-G multi-screen boards for mall directory, wayfinding and promotional display walls.

• OEM relationship: AndroidSBC private-label SKU shipped with Levant Mall Services branding and CE / FCC / RoHS files bundled.
• Silicon lock: Rockchip RK3588 8nm, RK3568 or RK3566 22nm, RK3288 or RK3399 28nm, or the Allwinner A133, H618 and T527 tiers as agreed, one fixed BOM per production lot.
• Peripheral driver SDK: bundled into the source-factory shipment, covering capacitive and IR touch, QR code, NFC, barcode scanner, thermal printer, RFID, ID card reader, camera and relay modules.
• Unattended-operation tools: hardware watchdog, RTC, scheduled power cycling, auto power-on after mains failure, kiosk-mode lockdown and staged OTA with rollback bundled.
• Compliance paperwork: CE / FCC / RoHS plus AGCOM conformity, all bundled into the Shenzhen source-factory shipment.

Levant Mall Services Digital Signage Manager for GCC Shopping Centres highlighted: Levant Mall Services runs directory and promotional walls off one controller, and the independent triple display output on the RK3588 tier let 55800 screens in Genoa carry different content from a single WF-G board.

Field Report: lobby directory terminal installation at a business hotel group

SHENZHEN, September 18, 2026 - Liang Shu, AndroidSBC field desk. The final gate was a driver autoload check: the WF-G3399 boards booted with the full peripheral set attached and enumerated every module before the dual-screen high-definition guide kiosk content service started. The WF-G3399 smart guide kiosk Android motherboard order for Genoa, Italy cleared the burn-in station on schedule and is en route via the Genoa - Shanghai lane.

The WF-G3399 dual-screen high-definition guide kiosk production lot includes the WF-G3399-A variant as the typical configuration, with payment-peripheral driver SDK and OTA content management bundled into the source-factory shipment. For Italy integrators, the AGCOM conformity plus CE marking with AGCOM radio interface notification paperwork is bundled.

Filed by Liang Shu, AndroidSBC field desk, SHENZHEN. CE plus AGCOM; family-run chain stores buy smaller batches but with a strong local-cert requirement.

WF-G3399 Application Scenarios

The WF-G3399 dual-screen high-definition guide kiosk sits inside a twelve-variant WF-G smart guide kiosk Android motherboard family from AndroidSBC, a Wanlin Manufacturing Group export brand. The WF-G3399-A configuration is the typical build for the hotel lobby and resort directory terminal use case, with payment-peripheral driver SDK and OTA content management bundled.

• Shopping centre floor directories and tenant finders: WF-G3399 plus WF-G1331 form the mall-side directory ladder, with independent dual display output and 4K HDMI.
• Compact countertop enquiry and price check terminals: WF-G6180 plus WF-G3399 are the usual pairing where housing depth is limited and the BOM target is fixed.
• Transit, hospital and campus wayfinding banks: WF-G5270 is the dedicated public venue SKU, with route planning, multi-language content and a -20C to 70C window.
• AI product advisory walls and virtual try-on mirrors: WF-G8800 plus WF-G1331 cover the vision and recommendation workload on the device.
• Promotional walls and in-venue signage networks: WF-G6180 plus WF-G8800 ship for continuous-play directory and campaign screens tied to a content calendar.
• Hotel, resort and casino lobby directories: WF-G1331 plus WF-G5270 carry the guest orientation flow in Genoa.
• Exhibition and museum interpretive display points: WF-G3399 is the compact SKU for exhibit-side content and catalogue browsing.
• Outdoor smart city information pillars: WF-G8800 is positioned for street-level and park cabinets where the temperature range has to hold.
• Venue programmes running in Genoa: mall directories, supermarket price check, pharmacy enquiry, transit wayfinding, hospital orientation, hotel lobby guides, museum exhibits, campus directories and outdoor information pillars.

Partnership Models for Genoa Buyers

The WF-G family is offered to Genoa and Italy partners on three commercial tracks, and the choice is about how much of the product the partner wants to put their own name on.

• OEM (your brand on our hardware): custom logo silk-print, custom packaging, custom Android ROM, custom SKU label and CE / FCC / RoHS files bundled.
• ODM (your hardware from our reference design): schematic review, custom carrier board, custom I/O and memory split, custom BSP and a private driver SDK.
• Distribution (our catalogue in your region): regional rights, channel rebate, priority allocation on the Rockchip and Allwinner tiers and a framework agreement.

For Italy partners the decision is commercial, not technical: the same WF-G board ships on all three tracks, and the difference is how much of it carries the partner brand in Genoa.

Frequently Asked Questions

Does the WF-G smart guide kiosk Android motherboard family support a dual-screen high-definition guide kiosk?

Answer: Yes. The WF-G smart guide kiosk Android motherboard family from AndroidSBC ships dual-screen high-definition guide kiosk as a stock configuration. The Rockchip RK3588, RK3568, RK3566, RK3288 and RK3399 tiers and the Allwinner A133, H618 and T527 tiers all run the dual-screen high-definition guide kiosk firmware baseline with the peripheral driver SDK bundled.

What is the real difference between the RK3399 tier and the other silicon tiers in the WF-G family?

Answer: There are eight silicon options in the WF-G family and RK3399 is one of them. RK3588 leads on AI and multi-screen, RK3568 leads on I/O breadth, RK3566 leads on cost per screen, T527 leads on industrial temperature, RK3288 and RK3399 cover 28nm refreshes, and A133 and H618 lead on BOM. AndroidSBC keeps one firmware baseline across all eight so Italy integrators can mix tiers inside one venue estate.

Can AndroidSBC handle CE / FCC / UKCA / RoHS / REACH paperwork for Italy?

Answer: Yes. For Italy buyers the standard bundle is CE / FCC / RoHS plus AGCOM conformity and CE marking with AGCOM radio interface notification, routed through Port of Genoa. AndroidSBC also keeps the EMC, ESD and surge immunity test reports on file for venue property handover in Genoa.

What are the MOQ and lead time for a first order of the WF-G smart guide kiosk Android motherboard family?

Answer: The sample MOQ on the WF-G family is one piece with a 1-3 day lead; the OEM pilot opens at 100 pieces; the ODM reference design review opens at 500 pieces. Mass production runs on a 15-30 day lead once the BOM is signed off.

Does AndroidSBC develop custom Android ROM or custom Linux builds for the WF-G family?

Answer: Yes. AndroidSBC ports Android 10 through Android 15, plus Linux, Ubuntu and Debian, on every WF-G tier. Custom ROM work includes the boot animation, the kiosk lockdown layer, the update channel and the peripheral driver package for Italy deployments.

How are software updates and long-term support handled on the WF-G family?

Answer: AndroidSBC handles updates as a supply commitment: a seven-year firmware window, a versioned SDK, staged OTA with rollback, and a documented migration path when a silicon tier reaches end of life. For Genoa estates that removes the usual two-year requalification cycle.

Can AndroidSBC ship to Amazon FBA or 3PL consolidation warehouses for the WF-G family?

Answer: Yes. Shipments can be consolidated into a 3PL or FBA destination for Genoa partners, with carton labelling, palletisation and the AGCOM plus CE marking with AGCOM radio interface notification paperwork prepared in Shenzhen before the lot leaves.

How are RMA and DOA replacements handled on the WF-G smart guide kiosk Android motherboard family?

Answer: AndroidSBC runs RMA from the factory, not from a distributor. DOA is replaced on evidence from buffer stock, field failures are analysed by the line that built the board, and the report goes back to the Italy integrator with the root cause.

Contact AndroidSBC: Start Your WF-G3399 Sourcing Conversation

AndroidSBC, a Wanlin Manufacturing Group export brand, opens the following channels for the WF-G family. Genoa integrators can reach the export desk through:

• Email: Androidsbc@163.com
• Export service hotline: +8613261677119
• Website: https://www.androidsbc.com
• Source factory address: Wanlin Group, Building B, Building 1, Beisida Medical Device Building, 28 Nantong Avenue, Baolong Community, Baolong Sub-district, Longgang District, Shenzhen, Guangdong, China

A 1-3 day sample lead applies to Genoa and Italy buyers, with a 15-30 day mass-production lead on bulk orders. AndroidSBC commits to a seven-year firmware update window on the WF-G family.